Metalworking Additives

5 Products

View as List Grid
Set Descending Direction
per page
  1. QUAKER ADDITIVE 4705
    This additive is designed for defoaming of water soluble metalworking fluids. This applies to soluble oils, solution synthetics and semi-synthetics. It provides effective control at a very cost competitive level. This additive is an organically modified silicone emulsion.
  2. KATHON 893 MW
    This product is a powerful fungicidal compound, which can be used as an additive in aqueous metalworking fluids. KATHON 893 MW offers excellent anti-fungal protection at use rates of 55 to 170 ppm on a post-addition basis. KATHON 893 MW is also compatible with KATHON 886 MW.STORAGE AND HANDLINGThe expected shelf life for this product is 2 years under normal storage conditions. This product, like most chemicals, should be stored out of direct sun light in an area where the temperature is between 40ºF (4.4ºC) and 110ºF (43ºC).SAFETY DATAThis product is very hazardous and proper handling and storage is critical. Avoid contact with skin and eyes. Prior to using this product, please consult the Material Safety Data Sheet for instructions regarding safe handling.
  3. KATHON 886 MW
    KATHON 886 MW is a powerful anti-microbial compound, which can be used as an additive in aqueous metalworking fluids. This product offers excellent microbiological protection at use rates of 55-125 ppm on a post-add basis.
  4. ADDITIVE HWL
    This additive is designed for use as a defoamer in water soluble metalworking fluids. This is a calcium acetate slurry designed to increase water hardness in order to reduce and/or eliminate foam.This product is to be used diluted into water. Always add product to water to ensure adequate mixing. Because this additive is a slurry, some flocculation may occur over time. Mix the product first before each use. This product is used based upon the known current level of hardness in the fluid and how much you wish to increase it. The following calculation should be employed to determine the use rate:A = Total volume of system (in gallons) D = Increase of hardness desired (in mg/liter) A x D = Gallons of additive required 201,655
  5. ADDITIVE AMP
    ADDITIVE AMP is designed for increasing the pH of water soluble metalworking fluids in solution or emulsion.ADDITIVE AMP is to be used diluted into water. Always add product to water to assure the best mixing and minimize any localized exotherms.This additive is used in increments of 1 gallon of additive into each 10,000 gallons of metalworking emulsion or solution until desired increase in pH is achieved. Allow the additive to mix well into the aqueous fluid and re-check pH before making more additions.

5 Products

View as List Grid
Set Descending Direction
per page