Body & Chassis Stamping

3 Products

Set Descending Direction
per page
  1. FERROCOTE 61 MAL HCL 1
    FERROCOTE® 61 MAL HCL 1 is a flexing, blank washing, blanking, stamping, and drawing lubricant. This product is a lubricant-rust preventive that is designed to be applied to sheet steel and/or blanks in any of the aforementioned operations.FLUID MAINTENANCEThis product is used as received. It should not be diluted with any type of solvent or oil. Dilution will significantly reduce its performance and quality. Concentration control is not an issue with this product because it is used as received. Please consult your Quaker representative for more information on proper fluid maintenance.
  2. FERROCOTE 6130
    FERROCOTE 6130 is an oil-based drawing and forming lubricant that can be used for blank washing, blanking, stamping, and bending operations. FERROCOTE 6130 is designed to be applied to ferrous and non-ferrous metal surfaces in any of the aforementioned operations while offering in-process and final protection for the formed part. \n\nMeets South Coast Air Quality Management District (SCAQMD) 2012 requirements under Rule 1144, ASTM E1868-10 (TGA) for metal protecting, general (corrosion preventives). This product can be applied by: • Flood • Flow-on • Immersion • Wipe-on • Electrostatic • Spray
  3. QUAKERDRAW 58 BF
    QUAKERDRAW® 58 BF is a barium-free, water-dilutable forming lubricant consisting of Quaker’s proprietary ester lubricant, extreme pressure and anti-wear agents in combination with organic corrosion inhibitors. It is a multifunctional fluid designed for use on severe, high speed punching and/or forming operations where previously only high performance, chlorinated extreme pressure oils or emulsifiable mineral oil based products would work. This completely synthetic product is recommended for use in both soft and hard waters. This product is recommended for use on cold rolled steel, galvanized steel, and aluminum. \n

3 Products

Set Descending Direction
per page